MWO-5-2350-262-35-2
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
MWO-5-2350-262-35-2 - Page 20 of 33
MWO 5-2350-262-35-2
2-15
WARNING
CARC paint is extremely toxic.
It can irritate skin and cause burns.
Avoid inhaling.
Use
only with adequate ventilation.
Avoid contact with skin, eyes, or clothing.
In case of
contact, immediately flush skin or eyes with water for at least 15 minutes.
Get medical
attention for eyes.
Failure to comply may result in injury to personnel.
NOTE
Steps 6 through 8 below apply to Figure 2-18.
6.
Remove cap screw (1) and flat washer (3) from the MCU base plate (4).
Retain cap screw and flat washer for
later use.
7.
Clean painted surface around hole (5) in MCU base plate (4).
8.
Install the ground wire (6) from the MCU wiring harness to the MCU base plate (4) using the cap screw (1)
and flat washer (3) from step f.6. above and with star washer (MS35335-35) (2), ensuring the attaching
surface on the MCU base plate is bare and unpainted.
1, 2, 3
5
4
6
Figure 2-18.
Installing MCU Ground Wire Connection.
Back to Top
