MWO-5-2350-262-35-4

ARMORED COMBAT EARTHMOVER (ACE), M9

MODIFICATION WORK ORDER

MWO-5-2350-262-35-4 - Page 163 of 207

MWO 5--2350--262--35--4

5--28

SECTION VII MODIFICATION COMPLETION -- CONTINUED

NOTE

Step f below applies to Figure 5--18.

f.

Reinstall access cover, 12332229, (1) (cover that was trimmed), in bowl area using three new

self--locking bolts, MS51095--360L, (3), and three saved flat washers (2). Tighten self--locking bolts as

specified. Refer to TM 5--2350--262--20--1, Hull Access Covers and Plug Replacement and Repair

procedure.

g.

Reinstall left and right actuator access panels in frames using four saved machine bolts per TM

5--2350--262--20--1, Actuator Access Plates Replacement.

h.

If not previously accomplished, install four hull access covers on bottom of hull per TM

5--2350--262--20--1, Hull Access Covers and Plug Replacement and Repair.

i.

If previously removed, install ejector on vehicle per TM 5--2350--262--20--1, Ejector Replacement.

j.

Ensure that vehicle is completely reassembled and apparently ready to resume normal operation.

k.

Refer to TM 5--2350--262--10 and perform applicable operating procedures to ensure vehicle is fully

mission capable.

Figure 5--18. Access Cover Location