MWO-9-2330-390-35-1
MODIFICATION WORK ORDER
MODIFICATION OF M1022A1 DOLLY SET; POSITIONING TUBE REINFORCEMENT
DECEMBER 2002
MWO-9-2330-390-35-1 - Page 5 of 48
MWO 9-2330-390-35-1
5
9.
SPECIAL TOOLS; TOOL KITS; JIGS; TEST, MEASUREMENT, AND
DIAGNOSTIC EQUIPMENT (TMDE); AND FIXTURES REQUIRED.
a.
Hand tools and tool kits necessary to apply MWO are listed:
NOMENCLATURE
NSN
CAGEC
SUPPLY CATALOG
Tool Kit, General Mechanic’s
50980
SC 5180-90-N26
Kit, Redundant Power
1730-01-4062585
21439
8D00220-1
Wrench, Twist Lock
21439
8D00136 (Provided w/ Dolly)
Drill Set, Twist
55719
SC 4910-95-CL-A74
Drill, Electric, Portable
81348
SC 4910-95-CL-A74
Welder, Short Arc Mig
30367
P/N SWM-14
b.
Tools necessary to apply MWO are contained in the following shop set:
NOMENCLATURE
NSN
CAGEC
SUPPLY CATALOG
Shop Equipment,
Automotive Maintenance
And Repair
19204
SC 4910-95-A74
10.
MODIFICATION PROCEDURE.
WARNING
Use extreme caution when handling heavy parts.
Lifting device is required
when parts weigh over 50 lb (23 kg) for a single person lift, over 100 lb (45
Kg) for a two person lift, and over 150 lbs (68 kg) for a three or more person
lift.
Keep clear of heavy parts supported only by lifting device.
Failure to
follow this warning may cause serious injury or death to personnel
NOTE
•
Hydraulic lines should be tagged before removal.
•
Positioning cylinder ports should be plugged with masking tape or other
suitable means as lines are disconnected or fittings are removed.
•
A suitable container should be used to catch any draining hydraulic fluid.
Ensure that all spills are properly cleaned.
a.
DOLLY PREPARATION
NOTE
•
Preparation procedures are the same for front and rear dollies.
1.
Uncouple
Dolly set from Tow vehicle
2.
From the transport or travel mode (Figure 2) perform operations needed to
detach front and rear dollies (Refer to Appendix A).
Back to Top
