TB-9-2320-279-13-1

TECHNICAL BULLETIN; AIR CONDITIONING SYSTEM

OPERATOR’S, UNIT AND DIRECT SUPPORT MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS

DECEMBER 2005

  TB-9-2320-279-13-1 - Page 410 of 524

TB 9-2320-279-13-1
0052-18
CAUTION
Strip wire after placing it through seal.
Failure to comply may cause damage to
equipment.
3.
Insert 1 in. (25 mm) of wire (6) through
seal (8).
4.
Strip end of wire (6), leaving 1/4 in. (6 mm)
of bare wire.
5.
Insert contact socket (9) in locating hole of
crimper using proper hole according to the
gage of wire (6).
6.
Slide seal (8) down to end of insulation on wire (6).
7.
Position wire (6) on contact socket (9).
8.
Press handles of crimper together until ratchet releases and crimping is complete.
9.
Repeat Steps 3 through 8 for wire (7).
10.
Push contact socket (9), seal (8), and wire (6) through position A on connector (10).
11.
Push contact socket (9), seal (8), and wire (7) through position B on connector (10).
12.
Close secondary lock (11) on connector (10).


Back to Top