TB-9-2320-279-13-P-2

TECHNICAL BULLETIN; CREW PROTECTION KIT

OPERATOR’S, UNIT AND DIRECT SUPPORT MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL)

SEPTEMBER 2005

TB-9-2320-279-13-P-2 - Page 111 of 460

TB 9-2320-279-13&P-2

UPPER BRUSH GUARD REPLACEMENT - CONTINUED

0018 00

0018 00-3

REMOVAL - CONTINUED

CLEANING AND INSPECTION

Clean and inspect all parts IAW

General Maintenance Instructions

(WP 0011 00).

INSTALLATION

1.

Install two threaded studs into second threaded hole from each outside end of upper brush guard (15). Hand tighten

studs.

2.

Install upper brush guard shim (18) over threaded studs.

WARNING

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-

dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of

heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-

sonnel.

NOTE

Upper brush guard weighs 131 lb (59 kg).

3.

Attach sling and lifting device to upper brush guard (15).