TB-9-2320-279-13-P-2

TECHNICAL BULLETIN; CREW PROTECTION KIT

OPERATOR’S, UNIT AND DIRECT SUPPORT MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL)

SEPTEMBER 2005

TB-9-2320-279-13-P-2 - Page 394 of 460

II

106700-7

Rev. -

Figure 20. “L” Bracket Installation.

r.

Apply Urethane Sealant (P/N 104302-1) to the outside of the Windshield Frame

(P/N 106721-1-103), as shown in Figure 21.

This will provide a seal around the

Windshield Armor (Glass) (P/N 113381-1) once it is installed.

FOR PROPER THREAT PROTECTION, THE TRANSPARENT WINDSHIELD

MUST BE CORRECTLY INSTALLED.

ENSURE THAT THE STENCIL MARKING

“INSIDE OF VEHICLE” IS LOCATED SO THAT THE IDENTIFIED SURFACE IS

FACING THE INSIDE OF THE CAB.

IMPROPERLY INSTALLED WINDSHIELD

ARMOR WILL NOT PERFORM AS INTENDED AND MAY RESULT IN INJURY

OR LOSS OF LIFE.

DO NOT WIPE OR SPRAY THE WINDSHIELD WITH ANY CHEMICALS

OTHER THAN ISOPROPYL ALCOHOL (USED TO CLEAN IT).

OTHER

CHEMICALS CAN DAMAGE THE WINDSHIELD ARMOR TO THE EXTENT

THAT THE ARMOR WILL NOT PERFORM AS INTENDED AND MAY RESULT

IN INJURY OR LOSS OF LIFE (I.E., HARSH CHEMICALS SUCH AS

CLEANING AGENTS OR INSECTICIDES MAY CAUSE THE BALLISTIC

WINDSHIELD TO WEAKEN / CRACK.)

Nut 0.250-20,

Washers 0.250 ID

“L” Brackets,

P/N 106746-1-103

Bolt, Hex Head,

0.250-20 x 1.750 Long,

Washers 0.250 ID

WARNING

WARNING