TB-9-2320-279-13-P-2

TECHNICAL BULLETIN; CREW PROTECTION KIT

OPERATOR’S, UNIT AND DIRECT SUPPORT MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL)

SEPTEMBER 2005

TB-9-2320-279-13-P-2 - Page 395 of 460

II

106700-7

Rev. -

Page 37

s.

Loosely attach the two lower Windshield Retaining Brackets (P/N 113383-1-103)

using 0.250-in fasteners to the Windshield frame, see Figure 21. Set the Windshield

Armor (P/N 113381-1) on the Retaining Brackets and over the openings of the

Windshield Frame (P/N 106721-1).

Complete the installation by securing the

Windshield Armor in place, using the remaining Windshield Retaining Brackets

(P/Ns 113383-1-103 and 113383-3-103), and tightening all the 0.250-in. fasteners, as

shown in Figure 21.

Figure 21.

Armor Windshield installation.

t.

If this is the first time the Windshield Armor has been installed on a vehicle, apply the

Cleaning Decal (P/N 104301-1) to the lower left hand corner of the Windshield Armor

(see Figure 22) so that it does not obstruct the driver’s / passenger’s view.

Remove

the protective covers from the transparencies.

Windshield Window Assembly,

P/N 113381-1

Nut 0.250-20,

Washer 0.250 ID

Hex Head Bolts,

0.250-20 x 1.000 Long,

Washers 0.250-In ID

Window Retaining

Brackets (Qty 4),

P/N 113383-3-103

Window Retaining

Brackets (Qty 4),

P/N 113383-1-103

Urethane Sealant

around perimeter

(dashed line)