TB-9-2320-280-35-13
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR SINGLE CHANNEL GROUND AND AIRBORNE RADIO SYSTEM (SINCGARS) AN/VRC-88F, AN/VRC-89F, AN/VRC-90F, AN/VRC-91F, AN/VRC-92F
OCTOBER 2006
CHANGE 1
TB-9-2320-280-35-13 - Page 37 of 148
5-13
TB 9-2320-280-35-13
7-6.
Remove paint from vicinity of three mounting slots (7) on integrated rack (1).
7-7.
Apply anti-seize compound to vicinity of three mounting slots (7) on integrated rack (1) as required.
Figure 5-18.
1
7
7
NOTE
Do not install mounting hardware on top of integrated rack at this
time. Not installing this hardware leaves the integrated rack free
to pivot to assist in routing of cabling. Secure rack only after all
cabling has been routed.
7-8.
Mount integrated rack (1) to existing radio rack mount (10) using screw (12), washer (11),
lockwasher (9), and nut (8). Repeat for opposite side. Do not tighten screws.
Figure 5-19.
8
9
10
12
11
8. NUT – MS35649-2382 – QTY. 2
9. LOCKWASHER – MS35338-46 – QTY. 2
11. WASHER – 2436163 – QTY. 2
12. CAPSCREW – B1821BH038C225N – QTY. 2
~
1
Back to Top
