TB-9-2320-280-35-13
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR SINGLE CHANNEL GROUND AND AIRBORNE RADIO SYSTEM (SINCGARS) AN/VRC-88F, AN/VRC-89F, AN/VRC-90F, AN/VRC-91F, AN/VRC-92F
OCTOBER 2006
CHANGE 1
TB-9-2320-280-35-13 - Page 38 of 148
5-14
TB 9-2320-280-35-13
Section VIII. INSTALLATION OF SINCGARS MOUNTING TRAY AND AMP GUARD
8-1.
Remove paint from vicinity of four mounting holes (6) on integrated rack (7) and vicinity of four
mounting holes (5) on bottom of mounting base (4).
8-2.
Apply anti-seize compound to vicinity of four mounting holes (6) on integrated rack (7) and four
mounting holes (5) on mounting base (4) as required.
NOTE
Two lockwashers and one nut are used on driver-side screws only.
8-3.
Install MT-6352/VRC mounting base (4) and amp guard (9) on integrated rack (7) with two
capscrews (2), four lockwashers (1), and two nuts (8). Secure MT-6352/VRC mounting base (4) to
integrated rack (7) with two capscrews (3) and two lockwashers (1).
8-4.
Place warning decal (10) on amp guard (9).
Figure 5-20.
1. LOCKWASHER – MS45904-72 – QTY. 6
2. CAPSCREW – B1821BH031F125N – QTY. 2
3. CAPSCREW – B1821BH031F100N – QTY. 2
4. MOUNTING BASE, MT-6352/VRC – A3013367-1 – QTY. 1
8. NUT – MS51968-5 – QTY. 2
9. AMP GUARD – 872842-1 – QTY. 1
10. DECAL – 861868-2 – QTY. 1
6
5
1
9
10
2
1
3
4
7
1
8
9
5
5
5
6
Back to Top
