TB-9-2320-280-35-13
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR SINGLE CHANNEL GROUND AND AIRBORNE RADIO SYSTEM (SINCGARS) AN/VRC-88F, AN/VRC-89F, AN/VRC-90F, AN/VRC-91F, AN/VRC-92F
OCTOBER 2006
CHANGE 1
TB-9-2320-280-35-13 - Page 68 of 148
5-40
TB 9-2320-280-35-13
Figure 5-56.
17. ANTENNA CABLE – A3014031-17 – QTY. 1
18. ANTENNA CABLE – A3014032-3 – QTY. 1
3
7
15
16
17
17
19
18
4
2
16
NOTE
Perform steps 15-5 through 15-8 for vehicles with SINCGARS
model AN/VRC-92F only.
15-5.
Route antenna cable (18) from mounting base (7) to MT-6353/VRC mounting base (19).
15-6.
Route power amp cable (15) from MT-6353/VRC mounting base (19) up through center access
hole (2) and connect power amp cable (15) to W1J1 cable (15.1).
15-7.
Route control cable (16) from MT-6353/VRC mounting base (19) up through center access hole (2) to
mounting base (7).
15-8.
Route antenna cable (17) from front of MT-6353/VRC mounting base (19), under integrated rack (3),
and under right-side tunnel insulation (4) towards rear of vehicle.
~
~
15.1
15
Change 1
Back to Top
