TB-9-2320-280-35-13
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR SINGLE CHANNEL GROUND AND AIRBORNE RADIO SYSTEM (SINCGARS) AN/VRC-88F, AN/VRC-89F, AN/VRC-90F, AN/VRC-91F, AN/VRC-92F
OCTOBER 2006
CHANGE 1
TB-9-2320-280-35-13 - Page 69 of 148
5-41
TB 9-2320-280-35-13
NOTE
It may be necessary to drill four 0.147-in. holes in right
wheelhouse/utility area before performing step 15-9.
15-9.
Route antenna cable (17) up B-beam. Secure with tape until antenna and cable are installed in
Section XXII.
15-10.
Route antenna cable (6) along right rear seat/utility area with four self-tapping screws (20) and
loop clamps (21).
15-11.
Route antenna cable (6) through right wheelhouse/utility area with existing grommet, retainer,
screws, and plain-assembled nuts. (Refer to TM 9-2320-280-20.)
20
6
6
17
21
20. SELF-TAPPING SCREW – 9421073 – QTY. 4
21. LOOP CLAMP – MS21333-75 – QTY. 4
21
Figure 5-57.
Back to Top
