TB-9-2320-280-35-13
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR SINGLE CHANNEL GROUND AND AIRBORNE RADIO SYSTEM (SINCGARS) AN/VRC-88F, AN/VRC-89F, AN/VRC-90F, AN/VRC-91F, AN/VRC-92F
OCTOBER 2006
CHANGE 1
TB-9-2320-280-35-13 - Page 77 of 148
5-49
TB 9-2320-280-35-13
Figure 5-66.
17-19.
Locate, mark, and drill one 0.147-in. hole (35) in top of windshield frame (30).
17-20.
Route PLGR antenna cable (9) on top of windshield frame (30) and secure with loop clamp (26) and
self-tapping screw (25).
17-21.
Route PLGR antenna cable (9) down through center access hole (29) of integrated rack (31), and coil
excess antenna cable (9) under integrated rack (31).
17-22.
Route PLGR power cable (33) from bracket (32) to right-side tunnel insulation (34).
NOTE
Loosen right-side tunnel insulation before performing step 17-23.
(Refer to TM 9-2320-280-20.)
17-23.
Route PLGR power cable (33) under edge of right-side tunnel insulation (34) to 24V terminal bar at
cab enclosure panel.
25. SELF-TAPPING SCREW – 9421073 – QTY. 1
26. LOOP CLAMP – MS21333-65 – QTY. 1
31. PLGR POWER CABLE – 9728558-10 – QTY. 1
25
35
26
9
30
31
32
33
34
29
~
~
Back to Top
