TB-9-2320-280-35-14
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR SINGLE CHANNEL GROUND AND AIRBORNE RADIO SYSTEM (SINCGARS) AN/VRC-88F, AN/VRC-89F, AN/VRC-90F, AN/VRC-91F, AN/VRC-92F
SEPTEMBER 2006
TB-9-2320-280-35-14 - Page 91 of 148
5-69
TB 9-2320-280-35-14
21. LOOP CLAMP – MS21333-112 – QTY. 3
23. LOOP CLAMP – MS21333-69 – QTY. 3
27. NUT – 9419143 – QTY. 1
29. LOOP CLAMP – MS21333-98 – QTY. 1
30. CAPSCREW – B1821BH025C075N – QTY. 1
Figure 5-90.
25-7.
Route SINCGARS antenna cable (11) down B-pillar (19) to cab enclosure panel (24).
25-8.
Locate, mark, and drill one 0.281-in. hole (28) in right overhead rail (20).
25-9.
Secure right-side SINCGARS antenna cable (11) to right overhead rail (20) with clamp (29),
screw (30), and nut (27).
NOTE
Clamps will be large to accommodate speaker cables installed later.
25-10.
Secure SINCGARS antenna cable (11) to B-pillar (19) with three clamps (21) and existing
screws (22).
25-11.
Secure SINCGARS antenna cable (11) to cab enclosure panel (24) with three clamps (23) and
existing screws (25).
25-12.
Route SINCGARS antenna cable (11) under integrated rack (26), up through access hole, and to
vicinity of SINCGARS mount.
~
~
19
21
22
23
25
20
~
26
~
20
27
28
29
30
11
~
24
Back to Top
