TB-9-2320-280-35-14
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR SINGLE CHANNEL GROUND AND AIRBORNE RADIO SYSTEM (SINCGARS) AN/VRC-88F, AN/VRC-89F, AN/VRC-90F, AN/VRC-91F, AN/VRC-92F
SEPTEMBER 2006
TB-9-2320-280-35-14 - Page 93 of 148
5-71
TB 9-2320-280-35-14
NOTE
Perform step 26-4 for vehicles with left rear cab enclosure panel
only.
26-4.
Cut 2x2 in. section (13) from left rear cab enclosure panel (11). Install grommet (12) in panel (11).
Reinstall cab enclosure panel (11). (Refer to TM 9-2320-280-20.)
26-5.
Locate, mark, and drill three 0.147-in. holes (8) along tunnel edge (9).
26-6.
Route INC-EPUU cable (1) and power cable (4) rearward under left-side B-beam (10) and along
tunnel edge (9).
26-7.
Secure INC-EPUU cable (1) and power cable (4) to tunnel edge (9) with three clamps (7) and
self-tapping screws (6).
11
13
2.00
1
4
10
5.50
B-PILLAR
2.00
2.00
12
6
7
6
7
8
6
7
8
9
8
~
~
11.00
11.00
8.00
Figure 5-92.
6. SELF-TAPPING SCREW – 9421073 – QTY. 5
7. LOOP CLAMP – MS21333-75 – QTY. 2
12. GROMMET – MS21266-1N – QTY. A/R
Back to Top
