TB-9-2320-280-35-14
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR SINGLE CHANNEL GROUND AND AIRBORNE RADIO SYSTEM (SINCGARS) AN/VRC-88F, AN/VRC-89F, AN/VRC-90F, AN/VRC-91F, AN/VRC-92F
SEPTEMBER 2006
TB-9-2320-280-35-14 - Page 97 of 148
5-75
TB 9-2320-280-35-14
Figure 5-95.
6
NOTE
• Remove right rear side rail, if necessary.
(Refer to TM 9-2320-280-20.)
• Front edge of upper antenna plate should be approximately
9.75 in. from edge of front bolts in wheelhouse.
27-3.
Locate screw (11) on right rear wheelhouse (8) and drill out rivet (10) from right rear
wheelhouse (8). Enlarge hole to 0.281 in.
27-4.
Position support plate (12) underneath left rear wheelhouse (8) and drill two 0.281-in. diameter
holes (13).
27-5.
Using upper antenna plate (6) as template, locate, mark, and drill thirteen 0.281-in. holes (7) and
three 0.408-in. holes (9) in left rear wheelhouse (8).
6. ANTENNA PLATE – A3104004-1 – QTY. 1
9
8
11
10
12
~
9.75
7
7
7
7
7
13
~
Back to Top
