TB-9-2320-302-13-P-2

CREW PROTECTION KIT PART 2 OF 3

TECHNICAL BULLETIN; OPERATOR'S, UNIT AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS AND REPAIR PARTS AND SPECIAL TOOLS LIST

JUNE 2007

TB-9-2320-302-13-P-2 - Page 316 of 396

TSB 0012 - LATCH PIN RETENTION

6 Feb 2006

REQUIRED TOOLS:

1/8” Drill Bit and Drill

1/8” x 3/4” Roll Pin

Hammer

Welder (Option 2 Only)

PROCEDURE:

OPTION 1:

1.) Drill a 1/8” hole through the latch

and pin, 3/4” deep, as shown.

2.) Install the Roll Pin to ensure permanent

retention of the Latch Pin.

3.) Repeat for 2nd Pin.

OPTION 2:

1.) Fillet Weld around the base of both pins.

This bulletin modifies the door Cam Latches to ensure permanent retention of

the linkage pins.

0039 00-22