TB-9-2320-302-13-P-2

CREW PROTECTION KIT PART 2 OF 3

TECHNICAL BULLETIN; OPERATOR'S, UNIT AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS AND REPAIR PARTS AND SPECIAL TOOLS LIST

JUNE 2007

  TB-9-2320-302-13-P-2 - Page 48 of 396

TB 9-2320-302-13&P-2
OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) - CONTINUED
0009 00
0009 00-2
FRONT
AND LEFT
SIDE
1
Before
Front Armor
a. Inspect center firewall armor and
cowl armor panels for damage, loose,
or missing mounting hardware.
Any panel or armor plate is damaged,
bent out of shape, misaligned, loose,
missing, or mounting bolts are loose or
missing.
b.Inspect center firewall armor and
cowl armor panels for areas of rust or
corrosion.
Any corrosion where area is unsound
and small pin holes are present, or a
rusted through condition is present.
c.Inspect center firewall armor and
cowl armor panels for nearby cracks
or elongation of bolt holes.
Any cracks that are longer than 1 in. or
two consecutive bolt holes that are elon-
gated.
d.Inspect center firewall armor and
cowl armor panels for any holes or
gouges.
Any complete penetration of the armor
(hole in the armor) or multiple gouges
1/4 in. or deeper within 3 in. of each
other.
e.Inspect left firewall armor panel for
damage, loose, or missing mounting
hardware.
Any armor panel assembly is damaged
or mounting hardware is loose or miss-
ing.
f. Inspect left firewall armor frames for
areas of rust or corrosion.
Any corrosion where area is unsound
and small pin holes are present, or a
rusted through condition is present.
g.Inspect windshield ballistic glass
mounting hardware for damage,
loose, or missing mounting hardware.
Any ballistic glass mounting hardware
is damaged, loose, or missing, or
mounting bolts are loose or missing.
h.Inspect exterior surface of windshield
ballistic glass for rock chips, cracks,
scratches, pitting, any damage that
expose glass below the first layer,
cloudiness, or any stickers that impair
vision.
Rock chips, cracks with spider webbing,
scratches, pitting, or damage in the exte-
rior layer of ballistic glass that expose
glass below the first layer, cloudiness
that impairs vision.
i. If dirty, clean windshield ballistic
glass (WP 0010 00).
Table 1. Preventive Maintenance Checks and Services (PMCS) - Continued.
Item
No.
Interval
Location
Procedure
Not Fully Mission
Capable If:
Item To
Check/
Service


Back to Top