TB-9-2320-302-13-P-2
CREW PROTECTION KIT PART 2 OF 3
TECHNICAL BULLETIN; OPERATOR'S, UNIT AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS AND REPAIR PARTS AND SPECIAL TOOLS LIST
JUNE 2007
TB-9-2320-302-13-P-2 - Page 54 of 396
TB 9-2320-302-13&P-2
OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) - CONTINUED
0009 00
0009 00-8
REAR
ROOF AND
RIGHT
SIDE
5
Before
Rear Cab
Armor
a. Inspect rear cab armor for damage,
loose, or missing mounting hardware.
Rear cab armor is damaged, loose, miss-
ing, or mounting bolts are loose or miss-
ing.
b.Inspect rear cab armor frames for
areas of rust or corrosion.
Any corrosion where area is unsound
and small pin holes are present, or a
rusted through condition is present.
c.Inspect emergency egress for damage.
Emergency egress is missing or dam-
aged.
d.Inspect emergency egress ballistic
glass mounting hardware for damage,
loose, or missing mounting hardware.
Any ballistic glass mounting hardware
is damaged, loose, or missing, or
mounting bolts are loose or missing.
e.Inspect exterior surface of emergency
egress ballistic glass for rock chips,
cracks, scratches, pitting, any damage
that expose glass below the first layer,
cloudiness, or any stickers that impair
vision.
Rock chips, cracks with spider webbing,
scratches, pitting, or damage in the exte-
rior layer of ballistic glass that expose
glass below the first layer, or cloudiness
that impairs vision.
Table 1. Preventive Maintenance Checks and Services (PMCS) - Continued.
Item
No.
Interval
Location
Procedure
Not Fully Mission
Capable If:
Item To
Check/
Service
REAR
ARMOR
EMERGENCY EGRESS
REAR
ARMOR
440-085
Back to Top
