TB-9-2320-335-13-P

TRUCK, UTILITY: EXPANDED CAPACITY, IAP/ARMOR READY

TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE AND REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL) INSTRUCTIONS

MAY 2008

TB-9-2320-335-13-P - Page 214 of 680

TB 9-2320-335-13&P

7-34

7-23. PARKING BRAKE CABLE REPLACEMENT

This task covers:

a. Removal

b.

Installation

INITIAL SETUP:

Tools

General mechanic’s tool kit:

automotive (Appendix B, Item 1)

Manual References

TM 9-2320-387-10

TM 9-2320-387-24-1

TB 9-2320-335-13&P, Appendix E

Equipment Condition

• Wheels chocked and parking brake released

(TM 9-2320-387-10).

• Access cover removed (para. 10-58.4).

• Muffler and catalytic converter removed

(TM 9-2320-387-24-1).

• Rear propeller shaft removed

(TM 9-2320-387-24-1).

Maintenance Level

Unit

NOTE

Replacement procedures for left and right side parking brake

cables are basically the same. This procedure covers the left side.

1.

Remove clevis pin (6), clevis bolt (2), washers (3) and (7), and clevis (1) from caliper lever (8).

2.

Remove parking brake cable (4) from cable bracket (5).

NOTE

Use 1/2 in. line wrench for removing parking brake cable from

caliper bracket.

3.

Remove retaining ring (11) from parking brake cable (4).

4.

Remove parking brake cable (4) from equalizer cable bar (9) and C-beam (10).

5.

Pull parking brake cable (4) forward and remove from vehicle.

1.

Install parking brake cable (4) over rear front crossmember (13) and muffler bracket (12).

2.

Slide parking brake cable (4) through C-beam (10) and install on equalizer cable bar (9).

3.

Secure parking brake cable (4) to C-beam (10) with retaining ring (11).

4.

Install parking brake cable (4) on cable bracket (5).

5.

Install clevis (1) on caliper lever (8) with washer (3), clevis bolt (2), washer (7), and clevis pin (6).

b. Installation

a. Removal