TB-9-2320-335-13-P
TRUCK, UTILITY: EXPANDED CAPACITY, IAP/ARMOR READY
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE AND REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL) INSTRUCTIONS
MAY 2008
TB-9-2320-335-13-P - Page 216 of 680
TB 9-2320-335-13&P
7-36
7-24. PARKING BRAKE ROD REPLACEMENT
This task covers:
a. Removal
b.
Installation
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Cotter pin (Appendix A, Item 19)
Locknut (Appendix A, Item 82)
Locknut (Appendix A, Item 87)
Manual References
TM 9-2320-387-10
TM 9-2320-387-24-1
TB 9-2320-335-13&P, Appendix E
Equipment Condition
• Wheels chocked and parking brake released
(TM 9-2320-387-10).
• Muffler and catalytic converter removed
(TM 9-2320-387-24-1).
• Rear propeller shaft removed
(TM 9-2320-387-24-1).
• Access cover removed (para. 10-58.4).
Maintenance Level
Unit
1.
Remove clevis pin (6), clevis bolt (2), washers (3) and (7), and clevis (1) from caliper lever (8).
2.
Remove parking brake cable (4) from cable bracket (5).
3.
Remove clip (13) and spread boot (14) to allow access to cotter pin (20).
4.
Remove cotter pin (20), washer (19), clevis bolt (16), and clevis (17) from bellcrank (15).
Discard cotter pin (20).
5.
Remove locknut (25), washer (24), capscrew (12), washer (11), spring (10), and spacer (23) from
body (21). Discard locknut (25).
6.
Remove locknut (28) and convex washer (27) from parking brake rod (22) and brake cable equalizer
bar (9). Discard locknut (27).
7.
Remove parking brake rod (22) from brake cable equalizer bar (9) by sliding parking brake rod (22)
forward.
8.
Remove clevis (17), nut (18), and insulater rod (26) from parking brake rod (22).
1.
Install spring (10) and spacer (23) on body (21) with washer (11), capscrew (12), washer (24), and
locknut (25).
2.
Install nut (18), clevis (17), and insulater rod (26) on parking brake rod (22).
3.
Slide parking brake rod (22) rearward through spring (10).
4.
Install parking brake rod (22) on brake cable equalizer bar (9) with convex washer (27) and
locknut (28). Tighten locknut (27) far enough to expose 3 to 5 threads on end of parking brake rod (22).
5.
Spread boot (14) and install clevis (17) on bellcrank (15) with clevis pin (16), washer (19), and
cotter pin (20).
6.
Install clip (13) on boot (14).
7.
Install parking brake cable (4) on cable bracket (5).
8.
Install clevis (1) on caliper lever (8) with washer (3), clevis bolt (2), washer (7), and clevis pin (6).
b. Installation
a. Removal
Back to Top
