TB-9-2320-387-35-1
SINGLE CHANNEL GROUND AND AIRBORNE RADIO SYSTEM (SINCGARS) AN/VRC-88F, AN/VRC-89F, AN/VRC-90F, AN/VRC-91F, AN/VRC-92F
TECHNICAL BULLETIN; INSTALLATION INSTRUCTIONS
OCTOBER 2005
TB-9-2320-387-35-1 - Page 71 of 92
5-47
68. LOOP CLAMP – MS21333-75 – QTY. 3
69. SELF-TAPPING SCREW – 9421073 – QTY. 2
13-29.
Route all cables (62) forward from step 13-26 through cargo access hole (64) and in between
tunnel (65) and right rear seat (63).
Figure 5-60.
NOTE
• Perform steps 13-30 and 13-31 if supplemental heater is not
installed. Perform 13-32 and 13-33 if supplemental heater is
installed.
• Use MS21333-75 clamp if LVOSS is not installed. Use
MS21333-77 if LVOSS is installed.
13-30.
Locate, mark, and drill three 0.147-in. diameter holes (66) in side of tunnel (67), evenly spaced
apart.
13-31.
Secure all cables (62) to side of tunnel (67) with three clamps (68) and self-tapping screws (69).
NOTE
Use MS21333-75 clamp if LVOSS is not installed. Use
MS21333-77 if LVOSS is installed.
13-32.
Locate, mark, and drill two 0.147-in. diameter holes (66) in side of tunnel (67), evenly spaced apart.
13-33.
Secure all cables (62) to side of tunnel (67) with two loop clamps (68) and self-tapping screws (69),
and clamp (68), existing bracket (71), and screw (70).
~
~
~
64
62
63
65
Figure 5-61.
~
~
~
66
62
67
65
68
69
68
69
68
67
66
70
71
69
69
62
68
~
TB 9-2320-387-35-1
Back to Top
