5-80
TB 9-2320-387-35-4
84. LOOP CLAMP – MS21333-75 – QTY. 3
85. SELF-TAPPING SCREW – 9421073 – QTY. 2
24-48.
Route all cables (79) forward from step 24-28 through cargo access hole (81) and in between
tunnel (82) and right rear seat (80).
Figure 5-104.
~
~
~
81
79
80
82
NOTE
• Perform steps 24-49 and 24-50 if supplemental heater is not
installed. Perform 24-51 and 24-52 if supplemental heater is
installed.
• Do not route TAC-SAT or HF radio speaker cables through
tunnel.
24-49.
Locate, mark, and drill three 0.147-in. diameter holes (83) in side of tunnel (82), evenly spaced
apart.
24-50.
Secure cables (79) to side of tunnel (82) with three clamps (84) and self-tapping screws (85).
24-51.
Locate, mark, and drill two 0.147-in. diameter holes (83) in side of tunnel (82), evenly spaced apart.
24-52.
Secure all cables (79) to side of tunnel (82) with two loop clamps (84) and self-tapping screws (85),
and clamp (84), existing bracket (87), and screw (86).
Figure 5-105.
~
~
~
83
79
82
83
84
85
84
85
84
82
83
86
87
85
85
79
84
~