TB-9-3950-253-13-P
PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2009
TB-9-3950-253-13-P - Page 341 of 704
0034-5
TB 9-3950-253-13&P
0034
LIFT FRAME SENSOR REMOVAL
00034
1. Disconnect electrical connector (Figure 6, Item 3) from lift frame sensor (Figure 6, Item 4).
2. Loosen two bolts (Figure 6, Item 1) in cable clamp (Figure 6, Item 2).
3. Remove lift frame sensor (Figure 6, Item 4) from cable clamp (Figure 6, Item 2).
Figure 6.
Lift Frame Sensor Removal.
0034
END OF TASK
CLEANING AND INSPECTION
00034
Clean and inspect all parts IAW WP 0020,
General Maintenance Instructions
.
END OF TASK
LIFT FRAME SENSOR INSTALLATION
00034
CAUTION
Incorrectly installed and configured sensors may result in damage to equipment.
1.
Loosen two bolts (Figure 6, Item 1) in cable clamp (Figure 6, Item 2) and insert lift frame sensor (Figure 6,
Item 4) into clamp.
2. Adjust lift frame sensor (Figure 6, Item 4) placement until end of sensor is flush with cable clamp (Figure 6,
Item 2) and tighten two bolts (Figure 6, Item 1).
3. Connect electrical connector (Figure 6, Item 3) to lift frame sensor (Figure 6, Item 4).
3
2
1
4
Back to Top
