TB-9-3950-253-13-P
PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2009
TB-9-3950-253-13-P - Page 384 of 704
TB 9-3950-253-13&P
Change 1
0037-8
0037
FOLLOW-ON TASKS – CONTINUED
NOTE
•
Add or remove shims equally on both right and left slider beds.
•
Shims are 0.04 in. (1 mm) thick. Divide the difference between measured value and chart
value by two to determine number of shims required per side.
•
Sum of A-B and C-D dimensions must equal 191.26 in. +/- 0.08 in. (4858 mm +/- 2 mm).
5. Locate recorded A-B dimension in Table 1. Compare recorded C-D dimension to corresponding C-D dimension
in Table 1.
6. If recorded C-D dimension is less than required value, remove shims from outboard side of front slider bed and
add shims to inboard side of front slider bed.
7. If recorded C-D dimension is greater than required value, remove shims from inboard side of front slider bed
and add shims to outboard side of front slider bed.
Prod Note: Keep Table 1 in place following step 7.
END OF TASK
END OF WORK PACKAGE
Table 1.
Slider Tolerances.
037
IF DIMENSION A-B IS
THEN C-D MUST BE
94.7 in. +/- 0.08 (2425 mm +/- 2 mm)
95.79 in. +/- 0.08 (2433 mm +/- 2 mm)
95.5 in. +/- 0.08 (2426 mm +/- 2 mm)
95.75 in. +/- 0.08 (2432 mm +/- 2 mm)
95.55 in. +/- 0.08 (2427 mm +/- 2 mm)
95.7 in. +/- 0.08 (2431 mm +/- 2 mm)
95.6 in. +/- 0.08 (2428 mm +/- 2 mm)
95.67 in. +/- 0.08 (2430 mm +/- 2 mm)
95.67 in. +/- 0.08 (2430 mm +/- 2 mm)
95.6 in. +/- 0.08 (2428 mm +/- 2 mm)
95.7 in. +/- 0.08 (2431 mm +/- 2 mm)
95.55 in. +/- 0.08 (2427 mm +/- 2 mm)
95.75 in. +/- 0.08 (2432 mm +/- 2 mm)
95.5 in. +/- 0.08 (2426 mm +/- 2 mm)
95.79 in. +/- 0.08 (2433 mm +/- 2 mm)
95.3 in. +/- 0.08 (2424 mm +/- 2 mm)
Back to Top
