TB-9-3950-253-13-P
PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2009
TB-9-3950-253-13-P - Page 380 of 704
TB 9-3950-253-13&P
Change 1
0037-4
0037
INSTALLATION
00037
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure any lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Failure to
follow this warning may result in injury or death to personnel.
NOTE
•
Front slider bed weighs 137 lb (62 kg).
•
Perform steps 1 through 5 for both right and left sides.
1. Attach sling and lifting device to front slider bed (Figure 2, Item 1).
WARNING
Components may fall during installation of pin. If necessary, support components during
installation. Failure to follow this warning may result in injury to personnel or damage to
equipment.
2. Use lifting device to install front slider bed (
Figure 2
, Item 1) on rear slider bed (
Figure 2
, Item 7).
3. Apply GAA to pin (
Figure 2
, Item 4).
NOTE
Install shims as noted during removal.
4. Install spacer (
Figure 2
, Item 3), shims (
Figure 2
, Item 2), and pin (
Figure 2
, Item 4) in front slider bed
(
Figure 2
, Item 1).
5. Install bolt (
Figure 2
, Item 6) and new locknut (
Figure 2
, Item 5) in rear slider bed (
Figure 2
, Item 7).
Back to Top
