TB-9-3950-253-13-P

PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)

TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST

JULY 2009

TB-9-3950-253-13-P - Page 408 of 704

0042-2

TB 9-3950-253-13&P

0042

REMOVAL

00042

NOTE

Perform steps 1 through 3 for both right and left sides.

1. Remove two grease fittings (Figure 1, Items 1 and 9) from rear slider assembly (Figure 1, Item 10).

2. Remove bolt (Figure 1, Item 2), star washer (Figure 1, Item 3), and washer (Figure 1, Item 4) from roller pin

(Figure 1, Item 5). Discard star washer.

3. Remove

roller pin (Figure 1, Item 5),

spacer (Figure 1, Item 6), angled roller (Figure 1, Item 7), and spacer ring

(Figure 1, Item 8) from rear slider assembly (Figure 1, Item 10).

END OF TASK

CLEANING AND INSPECTION

00042

Clean and inspect all parts IAW WP 0020,

General Maintenance Instructions

.

END OF TASK

INSTALLATION

00042

NOTE

Perform steps 1 through 4 for both right and left sides.

1.

Apply grease to roller pin (Figure 1, Item 5).

2. Install spacer ring (Figure 1, Item 8), angled roller (Figure 1, Item 7), spacer (Figure 1, Item 6), and roller pin

(Figure 1, Item 5) on slider assembly (Figure 1, Item 10).

3.

Install washer (Figure 1, Item 4), new star washer (Figure 1, Item 3), and bolt (Figure 1, Item 2) on roller pin

(Figure 1, Item 5).

4. Install two grease fittings (Figure 1, Items 1 and 9) on rear slider assembly (Figure 1, Item 10).