TB-9-3950-253-13-P

PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)

TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST

JULY 2009
TB-9-3950-253-13-P

  TB-9-3950-253-13-P - Page 92 of 704

TB 9-3950-253-13&P
Change 1
0008-14
0008
SECURE CONTAINER FOR TRANSPORT – CONTINUED
0008
Secure Transport Locks
0008
NOTE
Perform steps 1 through 13 for both right and left sides.
1. Remove clip (Figure 17, Item 12) from transport lock (Figure 17, Item 8).
2. At stowage assembly, lift handwheel lock (Figure 17, Item 7) and loosen handwheel (Figure 17, Item 9) to full
extension.
3. Rotate anvil (Figure 17, Item 13) and remove transport lock (Figure 17, Item 8) from stowage bracket
(Figure 17, Item 14).
4. Push transport lock (Figure 17, Item 8) upward into container corner casting (Figure 17, Item 6). Verify that
anvil (Figure 17, Item 13) is inserted into container corner casting.
5. Continue to support transport lock handwheel (Figure 17, Item 9) and turn it 90° clockwise.
6. Lower transport lock handwheel (Figure 17, Item 9) and check that anvil shoulders are now resting on inner
surface of container corner casting (Figure 17, Item 6).
7. Maintaining downward pressure on handwheel (Figure 17, Item 9), tighten handwheel until transport lock
(Figure 17, Item 8) is snug against container but loose enough to adjust position.
8. Remove clip (Figure 17, Item 10), bolt (Figure 17, Item 2), and transport lock arm (Figure 17, Item 3) from
stowage bracket (Figure 17, Item 1).
9. If necessary, remove clip pin (Figure 17, Item 11) from adjustment lever (Figure 17, Item 4), loosen adjustment
lever and adjust length of transport lock arm until clevis (Figure 17, Item 5) aligns with transport lock
(Figure 17, Item 8).
10. Install clevis (Figure 17, Item 5), bolt (Figure 17, Item 2), and clip (Figure 17, Item 10) on transport lock
(Figure 17, Item 8).
11. If loosened, tighten adjustment lever (Figure 17, Item 4) and install clip pin (Figure 17, Item 11).
12. Lift handwheel lock (Figure 17, Item 7) and tighten handwheel (Figure 17, Item 9) until transport lock
(Figure 17, Item 8) is secure against container corner casting (Figure 17, Item 6).
13. Ensuring it passes between two finger grips on handwheel (Figure 17, Item 9), lower handwheel lock
(Figure 17, Item 7).


Back to Top