TM-1-1500-344-23-4
CONSUMABLE MATERIALS AND EQUIPMENT FOR AIRCRAFT AND AVIONICS VOLUME IV
TECHNICAL MANUAL; CLEANING AND CORROSION CONTROL
SEPTEMBER 2013
TM-1-1500-344-23-4 - Page 7 of 92
NAVAIR 01-1A-509-4
TM 1-1500-344-23-4
01 September 2013
1-1.
GENERAL
. Consumable materials and
equipment listed in this volume shall be used for corrosion
control. Materials and equipment have been approved
only after extensive testing to prove their ability to
perform properly and effectively without damaging any
of the metallic or nonmetallic materials used in aircraft
or avionics. Only those materials listed in this manual
shall be used for cleaning or corrosion control. Materials
listed in other manuals shall be used only when required
procedures are not covered by this manual. When
approved materials are not available, substitutions shall
only be made by the appropriate Aircraft Controlling
Custodians (ACC) or System Program Manager (SPM).
1-2.
PURPOSE
. The purpose of this manual is to
provide ordering information for consumable materials
and equipment used to prevent, control, and repair
corrosion damage to aircraft and avionics.
CHAPTER 1
INTRODUCTION
This volume was prepared under the technical cognizance of the
Materials Engineering Division, NAVAIR North Island, San Diego, California.
1-3.
SCOPE
. The material in this manual contains
basic corrosion prevention and corrective maintenance
information to be used at Organizational, Intermediate,
and Depot levels.
1-4.
ARRANGEMENT OF MANUAL
.
1-4-1. A complete set of manuals to perform aircraft
cleaning and corrosion control functions consists of
Volumes I, II, and IV. A complete set of manuals to
perform avionics and electronics cleaning and corrosion
control functions consists of Volumes I, III, and IV.
1-4.2. Arrangement of Volume IV. Volume IV consists
of four chapters, arranged as shown in Table 1-1.
1-5.
RELATED PUBLICATIONS
. None.
Table 1-1. Outline of Volume IV
CHAPTER
TITLE
BRIEF DESCRIPTION
1
Introduction
This chapter presents the scope and layout of this volume.
2
Consumable Materials
for Corrosion Control
This chapter provides information on the approved materials for cleaning,
corrosion prevention, and corrosion control for aircraft and avionics.
3
Equipment for
Corrosion Control
This chapter provides information on approved equipment used for cleaning,
corrosion prevention, and corrosion control for aircraft and avionics.
4
Special Avionic
Equipment
This chapter lists the requirements for special cleaning equipment used in an
avionic corrosion control work center.
1-1/(1-2 Blank)
Back to Top
