TM-10-5411-205-13
SHELTER, ELECTRICAL EQUIPMENT - 250/G
TECHNICAL MANUAL; OPERATOR’S, UNIT, AND DIRECT SUPPORT MAINTENANCE MANUAL
MAY 1995
CHANGE 2
TM-10-5411-205-13 - Page 79 of 127
TM 10-5411-205-13
3-32.
Door Stay Assembly (cont).
e .
Assemble.
(Figure 3-34)
(1) Position two flat washers (16) and door stay rod (13) in place inside bracket (9)
end secure in place with pin (14).
(2) Push flat washer (15) in place from bottom of pin (14), and peen end of pin (14)
over to hold washer (15).
(3) Slide rod end (13) into channel assembly (6).
f .
Install.
(Figure 3-34)
(1) Position channel assembly (6) on door panel (outer or inner door) and secure to
panel with three phillips head screws (5) after dipping screws in sealer.
(2) Position bracket (9) in place on panel (shelter or outer door panel) and secure
with three hex-head screws (7) dipped in sealer, and three lock washers (8).
(3) Position spring tension clip (4) and secure to panel with two rivets (3) dipped in
.
(4) With a rivet (1) dipped in sealer, attach lanyard tab of detent pin (2) to door
panel (outer or inner door panel).
Figure 3-34.
Door Stay Assembly Repair and Replacement.
3-62
Back to Top
