TM-10-5411-205-13
SHELTER, ELECTRICAL EQUIPMENT - 250/G
TECHNICAL MANUAL; OPERATOR’S, UNIT, AND DIRECT SUPPORT MAINTENANCE MANUAL
MAY 1995
CHANGE 2
TM-10-5411-205-13 - Page 78 of 127
TM 10-5411-205-13
3-32.
Door Stay Assembly.
This task covers:
a Inspect
d. Repair
b. Remove
e.
Assemble
c.
Disassemble
f. Install
INITIAL SETUP
Tools
Materials/Parts
General Mechanic’s Automotive Tool Kit
Sealer (Item 28, Appendix D)
a.
Inspect.
(Figure 3-34)
(1) Inspect
(2) Inspect
(3) Inspect
(4) Inspect
for missing or damage hardware.
for wear, dents, or other damage.
that rod (13) moves freely.
for secured or damaged detent pin (2).
b.
Remove.
(Figure 3-34)
(1)
(2)
(3)
(4)
(5)
Drill out rivet (1) attaching lanyard tab of detent pin (2) and remove detent
Drill out tvo rivets (3) attaching spring tension clip (4) and remove clip (4).
pin.
Push door open and remove and retain three phillips head screws (5) attaching
door stay channel (6) to door panel (outer or inner door).
Remove and retain three hex-head screws (7) and lock washers (8) attaching
door stay bracket (9) to panel (shelter or inner door), and remove door stay
assembly (10).
Inspect condition of rivnuts (11 and 12) and replace if necessary (paragraph 3-
9.b).
c .
Disassemble.
(Figure 3-34)
(1) Push channel assembly (6) out of door
S
tay rod (13).
(2) Grind off end of pin (14) and remove flat washer (15).
(3) Remove pin (14) to release door stay rod (13) and two flat washers (16) from
bracket (9).
d .
Repair.
Repair of the door stay assembly consists of replacement of the damaged or
malfunctioning component.
3-61
Back to Top
