TM-10-5411-205-13
SHELTER, ELECTRICAL EQUIPMENT - 250/G
TECHNICAL MANUAL; OPERATOR’S, UNIT, AND DIRECT SUPPORT MAINTENANCE MANUAL
MAY 1995
CHANGE 2
TM-10-5411-205-13 - Page 68 of 127
TM 10-5411-205-13
3-25. Directional Vane Assembly and Air Intake Filter.
This task covers:
a. Inspect
b. Replace
INITIAL SETUP
Tools
Materials/Parts
General Mechanic’s Automotive Tool Kit
Sealer (Item 28, Appendix D)
a.
Inspect.
(1) Inspect for damaged directional vane assembly.
(2) Inspect for loose or missing attaching hardware.
b .
Replace.
(Figure 3-27)
(1)
(2)
(3)
(4)
Remove and retain four phillips head screws (1) and lock washers (2) and take
directional vane assembly (3) off inside of inner door assembly (4). Remove air
intake falter (5).
Inspect condition of rivnuts (6) and replace if necessary (paragraph 3-9. b).
Replacement rivnuts must have same inside diameter and thread size as rivnut
removed. Dip new rivnuts in sealer prior to installation.
Position air intake falter (5) in recess on inside of inner door assembly (4).
Position directional vane assembly (3) on inner door assembly (4) over falter (5).
Make sure vanes are aiming up toward interior of shelter, as shown in figure 3-
27. Dip four phillips head screws (1) in sealer and install with four lock
washers (2).
3-51
Back to Top
