TM-10-5411-205-13
SHELTER, ELECTRICAL EQUIPMENT - 250/G
TECHNICAL MANUAL; OPERATOR’S, UNIT, AND DIRECT SUPPORT MAINTENANCE MANUAL
MAY 1995
CHANGE 2
TM-10-5411-205-13 - Page 63 of 127
TM 10-5411-205-13
3-23.
Inner Door Assembly.
This task covers:
a Inspect
e. Test
b. Remove
f. Adjust
c.
Repair
d. Install
INITIAL SETUP
Tools
Materials/Parts
General Mechanic’s Automotive Tool Kit
Sealer (Item 28, Appendix D)
Conductive Compound (Item 33,
Appendix D)
a .
Inspect
(Figure 3-25)
(1) Inspect the inner door assembly (6) for external damage.
(2) Inspect the silicone weather gasket (8) for tightness.
(3) Inspect the RFI/EMI gasket (12) on a shielded shelter.
(4) Inspect the door for positive closing and proper operation.
(5) Inspect the air intake falter (9) for wear and cleanliness.
(6) Inspect louver assembly (10) and holder assembly (11) for damage and secure
mounting.
b .
Remove.
(Figure 3-25)
(1) Remove and retain three phillips head screws (1) attaching door stay channel (2)
to door panel, and pull channel away from door panel.
(2) Remove and retain four nuts (5), lock washers (4) and hex-head screws (3)
attaching each of the two hinges to outer door panel.
(3) Remove inner door assembly (6) and two hinge spacers (7).
c .
Repair.
Inner door assembly repair consists of the following
(1)
(2)
(3)
(4)
Door gasket replacement (paragraph 3-18).
Door handle assembly and latching mechanism replacement (paragraph 3-19).
Keeper assembly replacement (paragraph 3-20).
Hinge assembly replacement (paragraph 3-21).
3-46
Back to Top
