TM-10-5411-205-13
SHELTER, ELECTRICAL EQUIPMENT - 250/G
TECHNICAL MANUAL; OPERATOR’S, UNIT, AND DIRECT SUPPORT MAINTENANCE MANUAL
MAY 1995
CHANGE 2
TM-10-5411-205-13 - Page 62 of 127
TM 10-5411-205-13
3-22. Door Hasp.
This task covers:
Replace
INITIAL SETUP
Tools
General Mechanic’s Automotive Tool Kit
Materials /Parts
Sealer (Item 28, Appendix D)
Conductive Compound (Item 33, Appendix D)
Replace
(Figure 3-24)
(1)
(2)
(3)
(4)
(5)
(6)
Remove thumb screw (1) and crimp mesh washer (2) from inside of outer door.
Take hasp (3) off outer door.
Apply conductive compound on mounting surface of hasp (3).
Position hasp (3) on outside of outer door under handle (4).
Install thumb screw (1) with crimp mesh washer (2).
Apply a continuous bead of sealer around edge of hasp (3).
Figure 3-24. Door Hasp Replacement.
Change 1 3-45
Back to Top
