TM-10-5411-205-13
SHELTER, ELECTRICAL EQUIPMENT - 250/G
TECHNICAL MANUAL; OPERATOR’S, UNIT, AND DIRECT SUPPORT MAINTENANCE MANUAL
MAY 1995
CHANGE 2
TM-10-5411-205-13 - Page 60 of 127
TM 10-5411-205-13
3-21.
Hinge Assembly.
This task covers:
a. Inspect
b. Remove
c.
Disassemble
d. Assemble
e.
Install
INITIAL SETUP
Tool s
Materials/Parts
General Mechanic’s Automotive Tool Kit
Sealer (Item 28, Appendix D)
Conductive Compound (Item 33,
Appendix D)
b .
NOTE
The following repair procedures are the same for the inner door
(paragraph 3-23) hinge assembly.
Inspect.
(Figure 3-23)
(1) Inspect for damaged or non-functioning hinge assembly,
(2) Inspect for missing attaching hardware.
Remove.
(1) Remove and retain three nuts (1) and flat washers (2) attaching each hinge
from the inside of door panel.
(2) Remove and retain three hex head screws (3) and flat washers (2) and remove
hinge assembly (4) and laminated shim (5).
Disassemble.
(1) Grind off end of pin (6) and remove pin (6) and flat washer (7).
(2) Remove hinge leaf (8) and two flat washers (9) from bracket (10).
Assemble.
(1) Position hinge leaf (8) and
and
flat washers (9) in place inside bracket (10) and
secure in place with pin (6).
(2) Place flat washer (7) into pin (6) at opposite end of bracket (10) and peen end
of pin (6) over to hold washer (7).
c .
d .
3-43
Back to Top
