TM-5-2350-378-24-P

HYDRAULIC DIAGNOSTIC CENTER (HDC) SUPPORTING ARMORED COMBAT EARTHMOVER (ACE), M9

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

TM-5-2350-378-24-P - Page 480 of 790

TM 5--2350--378--24&P

0021 00--17

WINCH WILL NOT PULL RATED LOAD -- Continued

0021 00

Figure 14. Winch Shift Linkage

SHIFT LINKAGE ADJUSTMENT CHECK

Set control lever (Figure 14, item 2) in NEUTRAL detent (Figure 14, item 1).

Move lever (Figure 14, item 4) from side to side and measure for proper shift rod

(Figure 14, item 3) NEUTRAL position. Shift rod (Figure 14, item 3) must move at least

0.10 in (2.54 mm) in either direction without engaging LOW or HIGH gear. Total

NEUTRAL zone travel is 0.34 in. (8.64 mm). Go to block 7 if shift rod (Figure 14, item 3)

NEUTRAL travel is not within limits.