TM-5-2350-378-24-P

HYDRAULIC DIAGNOSTIC CENTER (HDC) SUPPORTING ARMORED COMBAT EARTHMOVER (ACE), M9

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

TM-5-2350-378-24-P - Page 613 of 790

TM 5--2350--378--24&P

0039 00--2

REPLACE HDC INTERCONNECTING HYDRAULIC HOSES AND TUBES -- Continued

0039 00

REMOVAL -- CONTINUED

NOTE

The initial setup in this task indicates the materials/parts, refer-

ences, and equipment conditions required to replace all associated

HDC hydraulic tubes and hoses. You need only to requisition the

items and perform the steps necessary for the hose or tube that

you are replacing.

Though in different locations, all hydraulic tubes and hoses are dis-

connected and removed in the same manner. This task covers the

replacement of only one hose. For location and configuration of

hoses and tubes, refer to TM 5--2350--262--20--2.

1.

Remove hose (Figure 1, item 3) from adapter (Figure 1, item 4) on primary manifold assembly (Figure 1,

item 5). Plug hose (Figure 1, item 3) and cap adapter (Figure 1, item 4) on manifold to prevent leakage.

2.

Remove other end of hose (Figure 1, item 3) from adapter (Figure 1, item 2) on main accumulator (Figure 1,

item 1). Plug hose (Figure 1, item 3) and cap adapter (Figure 1, item 2) to prevent leakage.

Figure 1. Replacing HDC Interconnecting Hydraulic Hoses and Tubes

END OF TASK

INSTALLATION

1.

Install hose (Figure 1, item 3) at main accumulator (Figure 1, item 1) adapter (Figure 1, item 2).

2.

Install other end of hose (Figure 1, item 3) at primary manifold (Figure 1, item 5) on adapter (Figure 1,

item 4).

END OF TASK