TM-5-2815-241-34-P
ENGINE, DIESEL NTC-290
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT, MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
MARCH 1987
TM-5-2815-241-34-P - Page 91 of 738
TM 5-2815-241-34&P
CYLINDER HEAD INSTALLATION - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
NOTE
Before performing step 3, coat cylinder head screws with lubricating oil.
3.
Cylinder head (4)
Twelve capscrews
Using 3/4-inch drive 1 1/16-inch socket
(5) and twelve new
and ratchet handle, screw in until snug.
hardened washers (6)
Do not tighten.
NOTE
When performing step 4, tighten capscrews in order shown in Cylinder Head Capscrew
Tightening Sequence.
4.
Twelve cap
screws (5)
Using 3/4-inch drive 1 1/16-inch socket
and 0 to 600 ft lb (0 to 840 N•m) torque
wrench, torque in steps sequence shown in
Cylinder Head Torquing Sequence.
CYLINDER HEAD CAPSCREW
TIGHTENING SEQUENCE
NOTE
Before performing step 5, coat packings with lubricating oil.
TA 242379
2-69
Back to Top
