TM-5-2815-241-34-P
ENGINE, DIESEL NTC-290
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT, MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
MARCH 1987
TM-5-2815-241-34-P - Page 94 of 738
TM 5-2815-241-34&P
COMPRESSION RELEASE SHAFT INSTALLATION
INITIAL SETUP
Tools
Wrench, box-end, 9/16-inch
Materials/Parts
Lockwasher
Oil, lubricating (item 12, appendix B)
Packing, preformed
ACTION
LOCATION
ITEM
REMARKS
1.
2.
3.
NOTE
Before performing step 1, coat packing with lubricating oil.
Compression
release
New preformed
shaft (1)
packing (2)
Front of cylinder
Compression release
block (4)
shaft (1)
Left rear of cylin-
Screw (6) and new
der block (5)
lockwasher (7)
Slide on and position in groove (3).
Put in.
Using 9/16-inch box-end wrench, screw in
and tighten.
TASK ENDS HERE
TA 242382
2-72
Back to Top
