TM-5-3805-254-14-P-2

TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW, IHC MODEL F-5070 (CCE)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT AND DEPT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS INFORMATION AND SUPPLEMENTAL MAINTENANCE INSTRUCTIONS)

JUNE 1980

TM-5-3805-254-14-P-2 - Page 383 of 894

TRUCK SERVICE MANUAL

ENGINE

7.

Lubricate gears, bushing, shafts, etc.

with clean

lubricating oil.

8.

Install by-pass spring, disc and seat or plate in filter

mounting head, if so equipped.

9.

Using new gasket, install cover or filter head to pump

body; replace pipe plugs if removed.

10.

Position spring in pressure regulator plunger open

end.

Install assembly in pump body, solid end of plunger

down; secure with retainer assembly.

Rotate drive shaft,

check end play.

Ref.

Table 7-5 (2).

Note:

Double lubricating oil pumps with the letter "L"

stamped following the part number (example 164163L)

have increased gear pocket depth to allow drive shaft

end clearance to meet specifications.

See Table 7-5 (2).

379