TM-5-3805-254-14-P-2

TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW, IHC MODEL F-5070 (CCE)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT AND DEPT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS INFORMATION AND SUPPLEMENTAL MAINTENANCE INSTRUCTIONS)

JUNE 1980

TM-5-3805-254-14-P-2 - Page 572 of 894

TRUCK SERVICE MANUAL

FUEL SYSTEM

11.

Carefully move assembly and rotor support to a

press.

12.

Lubricate rotor shaft O.D.

with STP oil or equivalent,

position compressor wheel on shaft.

Using a suitable

mandrel, place compressor wheel on shaft until wheel

seats against sleeve shoulder.

A press may be

necessary.

13.

Install self-locking nut on rotor shaft.

Place ST-1095

on torque wrench, hold nut with end wrench and turn

shaft with torque wrench to 20 to 24 ft-lb [27 to 33 N•m]

maximum torque.

Fig. 10-33.

Caution: Over-torquing nut will deform shaft, distort

thrust washer (if used) and cause oil leakage.

14.

Install collector housing on oil seal/diffuser plate and

bearing housing assembly, Fig. 10-34, align index marks,

secure with lockwashers and capscrews.

Tighten to 5 to

7ft-lb [7 to 10 N•m] torque.

Fig. 10-35.