TM-5-3805-254-20-2
TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW, IHC MODEL F-5070 (CCE)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL VOLUME 2 OF 2
JANUARY 1988
TM-5-3805-254-20-2 - Page 19 of 971
TM 5-3805-254-20-2
GENERATOR AND REGULATOR - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
1.
Generator pulley (1)
Two drivebelts (3)
Take off (page 2-665).
and crankshaft
pulley (2)
2.
Generator (4)
Screw (5), lock-
a.
Using 1/2-inch open-end wrench, un-
washer (6), and
screw and take out.
clamp (7)
b.
Get rid of lockwasher.
3.
Rubber boot (12)
Slide back and take off.
4.
Nut (9), lockwasher
a.
Using 7/16-inch open-end wrench, un-
(10), and wire
screw and take off.
connector (11)
b.
Get rid of lockwasher.
5.
Push-on
Pull off.
connector (8)
6.
Adjusting strap (13)
Screw (14) and
a.
Using 314-inch box-end wrench, un-
lockwasher (15)
screw and take out.
b.
Get rid of lockwasher.
7.
Mounting
Screw (17), nut
a.
Using two 3/4-inch box-end wrenches,
bracket (16)
(18), and lock-
unscrew and take out.
washer (19)
b.
Get rid of lockwasher.
CAUTION
Use care when performing steps 8 and 9.
Damage to generator could occur.
8.
Generator (4)
Carefully take out.
INSTALLATION
9.
Generator (4)
Carefully put in.
10.
Mounting
Screw (17), nut
Screw in until snug using 314-inch box-end
bracket (16)
(18), and new lock-
wrench.
washer (19)
11.
Adjusting strap (13)
Screw (14) and new
Screw in until snug using 3/4-inch box-end
lockwasher (15)
wrench.
2-668
Back to Top
