TM-5-3805-254-20-2
TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW, IHC MODEL F-5070 (CCE)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL VOLUME 2 OF 2
JANUARY 1988
TM-5-3805-254-20-2 - Page 9 of 971
TM 5-3805-254-20-2
WARNING
Due to excessive weight, assistance will be needed to lift and take off exhaust diverter.
WARNING
When removing battery cables, disconnect ground cable first.
When installing battery cables, connect
ground cable last.
When two ground cables are used, both cables must be disconnected prior to working
on equipment where shorting of cables can occur.
In correct cable replacement sequence is extremely
dangerous.
Accidental contact of tools with vehicle causes direct short, resulting in arcing and instant
heating of tool and causing painful burns.
Shorted battery may explode, causing injury to personnel.
WARNING
When removing battery cables, disconnect negative (-) cable first.
Failure to observe this precaution
could cause injury to personnel or damage to equipment.
WARNING
When installing battery cables, connect negative (-) cable last.
Failure to observe this precaution could
cause injury to personnel or damage to equipment.
WARNING
Do not operate engine after removing air filter element.
Foreign matter could enter turbocharger air inlet
pipe and could cause damage to turbocharger or injury to personnel.
WARNING
Do not touch heater coil of glow plug when testing.
Severe personal injury could occur.
WARNING
Safety props and support blocks must be used to support dump body to prevent falling and causing injury
to personnel.
WARNING
Be careful when removing radiator cap.
If engine is hot, escaping steam could burn you.
Use a rag to
cover radiator cap.
Unscrew cap just enough to allow any built-up pressure to escape.
When all pressure
has been relieved, unscrew cap and take off.
WARNING
Rubber apron, safety gloves, and safety goggles must be worn when working with batteries.
Failure to
observe this precaution could cause serious injury to personnel.
WARNING
Although KEY SWITCH must be on and battery ground cable connected to test electrical circuit voltage,
turn off KEY SWITCH and disconnect battery ground cable before doing resistance tests or replacing
parts.
This will keep you from getting shocked and prevent damage to parts and equipment.
f
Back to Top
