TM-5-3895-371-24-P

BITUMINOUS DISTRIBUTOR BODY M918, MODEL D-63

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL WITH REPAIR PARTS AND SPECIAL TOOLS LIST

MARCH 1981

TM-5-3895-371-24-P - Page 184 of 330

TM 5-3895-371-24 & P

Compressed air used for cleaning purposes will not

exceed 30 psi. Use only with effective chip guarding

and personal protective equipment (goggles/shield,

gloves, etc.).

(b)

Wash reworked cover in SD-2 solvent and dry with compressed air. Check against

tolerances in figure 3-44. If the reworked pump cover (21, fig. 3-4) does not fall within the tolerance

limits, it must be discarded.

NOTE

It is important that if either the inner or outer race is

to be replaced, the entire bearing be replaced.

(23)

If outer race of bearing (13) was removed during disassembly or if the inner race was

removed and replaced, install outer race in pump cover (21) using an arbor press and plug of proper size.

Figure 3-44. Pump Cow Rework specifications.

3-39