TM-5-3895-372-20
CONCRETE-MOBILE MIXER BODY M919, MODEL 8CM-24/F
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL
AUGUST 1980
TM-5-3895-372-20 - Page 71 of 694
TM 5-3895-372-20
POWER TRAIN.
4-10. UNIVERSAL JOINTS MAINTENANCE (Continued).
LOCATION/ITEM
ACTION
REMARKS
A.
REMOVAL (Continued).
1.
Two hex bolts (13), hex
Remove as needed.
nuts (11), and washers
(12).
2.
Two set screw
lock wires (4).
Remove.
3.
Two yoke collar set-
Loosen
Two on each U-joint.
screws (3).
NOTE
The two U-joints at the rear of the vehicle have roll pins. Tap out these roll pins with a drift and
hammer.
4.
Shafts (5) and
Slide apart. Remove
It may be necessary to tap loose
universal joint.
universal joint assembly.
with a hammer.
B.
DISASSEMBLY
.
5.
Grease fitting (1).
Remove from cross (10).
Tap bearings only hard enough to break them away from snap rings.
6.
Four bearings (7).
Use a soft drift to break
away from snap rings (6).
7.
Four snap rings (6).
Remove.
8.
Four bearings (7).
Remove.
You can push the first bearing
out of each yoke by tapping
gently on the opposite bearing.
Tap cross end to push out sec-
ond bearing.
9.
Four gaskets (8) and
Remove.
retainers (9).
10
Cross (10) and-two
Separate.
yokes (2).
4-22
Back to Top
