TM-5-3895-372-20
CONCRETE-MOBILE MIXER BODY M919, MODEL 8CM-24/F
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL
AUGUST 1980
TM-5-3895-372-20 - Page 73 of 694
TM 5-3895-372-20
POWER TRAIN.
4-10. UNIVERSAL JOINTS MAINTENANCE (Continued).
LOCATION
ACTION
REMARKS
C.
CLEANING AND INSPECTION.
WARNING
Compressed air used for cleaning purposes will not exceed 30 psi. Use only with effective chip guarding
and personal protective equipment (goggles/shield, gloves, etc.).
11.
Yokes (2).
a.
Clean with SD-2 dry cleaning solvent.
b.
Dry with compressed air.
Bearings (7) and cross (10) should be replaced as a set. If the cross or any bearing is
damaged, replace the set.
12.
Yokes (2).
Inspect for:
a.
Cracks.
b.
Wear.
c.
Nicks.
d.
Burrs.
D.
ASSEMBLY.
13.
Four new retainers
Place on cross (10).
(9) and gaskets (8).
14.
Cross (10).
Place between two yokes (2).
15.
Four bearings (7).
Use rawhide mallet to tap
bearings into yokes.
16.
Four snap rings (6).
Set in grooves of yoke (2).
17.
grease fitting (1).
Install in cross (10).
E.
INSTALLATION
.
18.
Two yokes (2).
a.
Press onto shaft (5).
b.
Aline punch marks.
19.
Two setscrews (3).
Tighten firmly, then install
Check that shafts do not slip in
two setscrew lockwires (4).
joints.
4-24
Back to Top
