TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 487 of 734

TM 5-5420-202-20-2

MANIFOLD HEATER FUEL FILTER AND INPUT FUEL LINE REPLACEMENT (Sheet 8 of 8)

Fuel Filter Input Fuel Line Replacement (Sheet 1 of 1)

TOOLS: 1/2 in. open end wrench

5/8 in. open end wrench

SUPPLIES: Clean bucket or drip pan

REFERENCE:

TM 5-5420-202-10

PRELIMINARY PROCEDURE:

Remove engine access covers (pages 17-11 and 17-13)

REMOVAL:

CAUTION

When removing or installing fuel lines care must be taken

1.

2..

not to damage fittings and threads or twist or distort fuel

lines or hoses.

NOTE

Use a suitable container to catch any fuel that may leak out

wherever any part of the fuel

disconnected.

Using 1/2 inch and 5/8 inch open end wrenches,

(A) from adapters (B and C).

Remove tube assembly (A).

INSTALLATION:

system is loosened or

disconnect both ends of tube assembly

1.

Position tube assembly (A) to adapter (B and C).

2. Using 1/2 inch and 5/8 inch open end wrench, install tube assembly to adapters.

3.

operate purge pump (TM 5-5420-202-10) and check for leaks. If leak is found, tighten

connection as required.

4.

Install engine access covers (pages 17-12 and 17-14).

End of Task

TA248376

7-252