TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 479 of 734

TM 5-5420-202-20-2

FUEL INLET FLUID PRESSURE FILTER REPAIR (Sheet 2 of 2)

CLEANING AND INSPECTION:

1. Inspect for broken or cracked components. Replace as necessary.

WARNING

Dry cleaning solvent P-D-680 is toxic and flammable.

To prevent personal injury, wear

protective goggles and gloves and use only in a well-ventilated area. Avoid contact with skin

eye, and clothes and don’t breathe vapors.

Do not use near open flame or excessive heat. The

flash point for Type #1 Dry Cleaning Solvent is 100°F (38

0

C) and for Type # 2 is 138

0

(50

0

C).

If you become dizzy while using cleaning solvent, get fresh air immediately and get medical aid.

If contact with eyes is made, wash your eyes with water and get medical aid immediately.

2.

Clean filter bowl, element, and spring with dry cleaning solvent and cloth.

3.

WARNING

Compressed air used for cleaning purposes

will not exceed 30 psi. Use only with

effective chip guarding and personnel

protective

equipment

goggles/shield,

gloves, etc).

Blow low-pressure, compressed air through

filter element to remove dirt particles.

Replace element if damaged.

ASSEMBLY:

1. Place new preformed packing (A) in position on filter bowl (B).

2. Place filter element and spring (C) in filter head (D).

3. Place filter bowl (B) and filter head (D) together.

4. Using wrench, screw together filter bowl (B) and

filter head (D).

5. Install fuel filter (page 7-248).

End of Task

7-244

TA248368