TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

  TM-5-5420-202-20-2 - Page 560 of 734

TM 5-5420-202-20-2
ACCELERATOR LINKAGE BULKHEAD FLANGE REPLACEMENT (Sheet 2 of 3)
2.
Using pliers, remove cotter pin (C) from
pin (D).
3.
Remove pin (D).
4.
Holding rod end (E) with 7/16 inch wrench, use 1/2 inch wrench to back off nut (F). Use
chalk to mark rod threads as close as possible to rod end.
5.
Using 7/16 inch and 1/2 inch wrench, remove rod end (E) and nut (F) from rod (G).
6.
Using socket with extension, remove two nuts (H) and lockwashers (J) securing flange
(K) to plate (L).
7.
Pull flange (K) off rod.
8.
Using vise, hammer, and punch, drive two seals (M) and bearing (N) out of flange (K).
Go on to Sheet 3
7-325


Back to Top