TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

  TM-5-5420-202-20-2 - Page 558 of 734

TM 5-5420-202-20-2
ACCELERATOR LINKAGE ENGINE CONTROL REPLACEMENT (Sheet 2 of 2)
REMOVAL:
1.
Using 7/16 inch wrench, remove screw
2.
Using two 7/16 inch wrenches, remove
(E) and Nut (F).
3.
Using 1/2 inch wrench and 7/16 inch wrench,
loosen nuts (G) from stud (H).
Count and write down number of turns needed to
unscrew rod ends (J).
NOTE
Count and write down number of turns needed to unscrew
rod ends (J).
4.
Unscrew rod ends (J) and nuts (G) from stud (H).
CLEANING AND INSPECTION:
1.
Clean all parts using dry cleaning solvent and clean rags.
2.
Inspect all parts for bends, cracks, stripped threads, wear, or other defects. Replace
defective parts.
INSTALLATION:
1.
Install nuts (A) onto stud (B).
2.
Screw rod ends (C) to same number of
turns recorded for removal on stud (B).
3.
Using 1/2 inch wrench and 7/16 inch
wrench, tighten nuts (A).
4.
Position rod assembly in place.
5.
Using two 7/16 inch wrenches, install
screw (D) and nut (E).
6.
Using 7/16 inch wrench, install screw (F).
7.
Install engine upper access cover (page 17-12)
End of Task
7-323


Back to Top