TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 718 of 734

TM 5-5420-202-20-2

ENGINE COOLING FAN REPLACEMENT (Sheet 3 of 4)

6.

7.

8.

9.

Using slip joint pliers, remove 16 cotter

pins (G).

Using 1/2 inch socket and open end

wrench, remove 16 nuts, bolts, and washers

(H) holding fan (J) to hub (K).

Place block of wood on hub (K). Using

hammer, strike block of wood until

hub (K) is separated from fan (J).

Inspect hub (K) for damages. Replace

hub if damaged.

INSTALLATION:

1.

Position hub (A) on fan (B) machined

surface up (marked top).

2.

Using 1/2 inch socket and open end

wrench, install 16 bolts, nuts, and washers

(C). Using torque wrench, torque nuts

to 15-20 lb-ft (20-27 NŽm).

3.

Using slip joint pliers, install 16 new

cotter pins (D).

Go on to Sheet 4

9-57